Loading ...
Loading ...
Loading ...
PROGRAMMING HomeLink
®
To program your HomeLink
®
Transceiver to
operate a garage door, gate, or entry door
opener, home or office lighting, you need to be
at the same location as the device. Note:
Garage door openers (manufactured after
1996) have “rolling code protection”. To pro-
gram a garage door opener equipped with
“rolling code protection”; you will need to use
a ladder to get up to the garage door opener
motor to be able to access the “smart or learn”
program button.
1. To begin, push and hold the 2 outer
HomeLink
®
buttons (to clear the memory)
until the indicator light
*
A
blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held transmitter
1 - 3 inches away from the HomeLink
®
surface.
3. Using both hands, simultaneously push and
hold both the HomeLink
®
button you want to
program and the hand-held transmitter
button. DO NOT release the buttons until
step 4 has been completed.
4. Hold down both buttons until the indicator
light on HomeLink
®
flashes, changing from a
“slow blink” to a “rapid blink”. This could
take up to 90 seconds. When the indicator
light blinks rapidly, both buttons may be
released. The rapidly flashing light indicates
successful programming. To activate the
garage door or other programmed device,
push and hold the programmed HomeLink
®
button and release it when the device
begins to activate.
5. If the indicator light on HomeLink
®
blinks
rapidly for two seconds and then turns solid,
HomeLink
®
has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train
HomeLink
®
, and completing the program-
ming may require a ladder and another
person for convenience.
6. Push and release the program button
located on the garage door opener’s motor
to activate the “training mode”. This button is
usually located near the antenna wire that
hangs down from the motor. If the wire
originates from under a light lens, you will
need to remove the lens to access the
training button.
NOTE:
Once you have pushed and released
the training button on the garage door
opener’s motor and the “training light”
is lit, you have 30 seconds in which to
Instruments and controls 2-59
Loading ...
Loading ...
Loading ...