Loading ...
Loading ...
Loading ...
2-60 Instruments and controls
perform step 7. For convenience, use
the help of a second person for assis-
tance when performing this step.
7. Quickly (within 30 seconds of pushing and
releasing the garage door opener training
button) and firmly push and release the
HomeLink
®
button that you have just pro-
grammed. Push and release the HomeLink
®
button up to three times to complete the
training.
8. Your HomeLink
®
button should now be
programmed. To program the remaining
HomeLink
®
buttons for additional door or
gate openers, follow steps 2 through 8 only.
NOTE:
.
Do not repeat step 1 unless you
want to “clear” all previously pro-
grammed HomeLink
®
buttons.
.
If you have any questions or are
having difficulty programming your
HomeLink
®
buttons, please refer to
the HomeLink
®
web site at: www.
homelink.com or call 1-800-355-
3515.
PROGRAMMING HomeLink
®
FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held trans-
mitter to HomeLink
®
, continue to push and hold
the HomeLink
®
button (see steps 2 through 4
under “Programming HomeLink
®
” earlier in this
section) while you push and re-push (“cycle”)
your hand-held transmitter every 2 seconds until
the indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING HomeLink
®
UNIVER-
SAL TRANSCEIVER
The HomeLink
®
Universal Transceiver (once
programmed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink
®
Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-DIAG-
NOSIS
If HomeLink
®
does not quickly learn the hand-
held transmitter information, perform the follow-
ing steps.
. Replace the hand-held transmitter batteries
with new batteries.
. Position the hand-held transmitter with its
battery area facing away from the
HomeLink
®
surface.
. Push and hold both the HomeLink
®
and
hand-held transmitter buttons without inter-
ruption.
. Position the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
HomeLink
®
surface. Hold the transmitter in
that position for up to 15 seconds. If
HomeLink
®
is not programmed within that
time, try holding the transmitter in another
position while keeping the indicator light in
view at all times.
If you continue to have programming difficulties,
please contact the NISSAN Consumer Affairs
Department. The phone numbers are located in
the Foreword of this Owner’s Manual.
Loading ...
Loading ...
Loading ...