Loading ...
Loading ...
Loading ...
Perform the following procedure to mount the
license plate.
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
. License plate bracket
. J-nut 62
. Screw 62
. Screw grommet 62
1. Align the height of the license plate bracket
with the position of
*
A
.
2. Align the position
*
B
of the license plate
bracket with the thin line on the upper part of
the opening section of the bumper.
3. To determine where to drill the hole, mark
along both sides of the mounting holes and
license plate screw holes using a felt-tip
pen.
4. Remove the license plate bracket and
connect the arcs from the ovals. Mark the
point in the center of each oval. These are
pilot drilling locations.
Use a 0.39 in (10 mm) drill bit for the
mounting holes and a 1.57 in (40 mm) drill
bit for the license plate screw holes and
carefully open holes in the places marked.
(Make sure that the drill only goes through
Technical and consumer information 9-9
INSTALLING FRONT LICENSE PLATE
Loading ...
Loading ...
Loading ...