Loading ...
Loading ...
Loading ...
©
2017 DJI All Rights Reserved.
43
MATRICE 600 PRO
User Manual
Stopping the Motors
There are two methods to stop the motors.
Method 1: When the aircraft has landed, push the throttle down and hold. The motors will stop after 3
seconds.
Method 2: When the Matrice 600 Pro has landed, push the throttle stick down, then perform the CSC
command to stop the motors. Release both sticks once the motors have stopped.
Stopping the Motors Mid-ight
Push the left stick to the bottom inside corner and press the RTH button at the same time. Only stop
the motors mid-ight in emergency situations when doing so can reduce the risk of damage or injury.
Flight Test
Takeoff / Landing Procedures
1. Place the aircraft on an open, at area on the ground with the rear of the aircraft facing you.
2. Power on the remote controller and your mobile device, and then one of the Intelligent Flight Batteries.
3. Launch the DJI GO app and enter Camera View.
4. Wait until the Aircraft Status Indicator blinks green. This means the Home Point is recorded and it is
safe to y. If it blinks yellow, the Home Point has not been recorded and you should not take off.
5. Push the throttle stick up slowly to take off or use Auto Takeoff.
6. To land, hover over a level surface, toggle the landing gear control switch to lower the landing
gear, and then gently pull down on the throttle stick to descend slowly.
7. After landing, execute the CSC command or push the throttle stick down for 3 seconds until the
motors come to a stop.
8. Turn off one of the Intelligent Flight Batteries and then the remote controller.
When the Aircraft Status Indicator blinks yellow rapidly during ight, the aircraft has entered
the Failsafe mode.
The Aircraft Status Indicator will blink red slowly for a Low Battery Level warning, and blink
red rapidly for a Critically Low Battery Level warning during ight.
Method 1 Method 2
OR
When using method 2 to stop the motors, the aircraft may rollover if it doesn’t touch the ground
completely. Please use it with caution. Method 1 is recommended for stopping the motors.
Loading ...
Loading ...
Loading ...