Loading ...
Loading ...
Loading ...
©
2017 DJI All Rights Reserved.
13
MATRICE 600 PRO
User Manual
Charging Protection LED Display
The table below describes the battery protection mechanisms and their corresponding LED patterns.
Battery Level Indicator While Charging
LED1 LED2 LED3 LED4 Indicator Pattern Battery Protection Item
LED2 blinks twice per second Overcurrent detected
LED2 blinks three times per second Short circuit detected
LED3 blinks twice per second Overcharge detected
LED3 blinks three times per second Charger overvoltage detected
LED4 blinks twice per second
Charging temperature is too
low (<5°C)
LED4 blinks three times per second
Charging temperature is too
high (>40°C)
After any of the above protection issues are resolved, press the power button to turn off the Battery
Level Indicator. Unplug the Intelligent Flight Battery from the battery charger and plug it back in to
resume charging. Note that you do not need to unplug and plug the battery charger in the event of a
charging temperature error; the battery charger will resume charging when the temperature falls within
the normal range.
DJI does NOT take any responsibility for damage caused by third-party battery chargers.
Calibrating the Battery Capacity:
To effectively calibrate the capacity of the Intelligent Flight Battery, it is recommended to
charge and discharge the battery thoroughly for every 10 charge-and-discharge cycles.
Choose one of the following methods to discharge battery. After discharging the battery, fully
charge the battery to nish the calibration.
Slow:
Place the battery into the Matrice 600 Pro’s battery compartment and power it on.
Leave it on until there is less than 5% battery level, or until it can no longer be turned on.
Check the battery level in the DJI GO app.
Fast:
Fly the Matrice 600 Pro outdoors until there is less than 5% battery level, or until the
battery can no longer be turned on.
Loading ...
Loading ...
Loading ...