Loading ...
Loading ...
Loading ...
7
Power Supply and Inert Gas Connections
Preparing to Use Your Wine
Dispenser for the First Time
WARNING
Do not use any power supply other than the one provided
with the system or a Dacor approved replacement. Do
not attempt to modify or bypass the power supply.
1. If not already connected, plug one end of the
plastic gas tubing (provided) into the inert gas
connector at the back of the wine dispensing
system. IMPORTANT: Do not cut or shorten the
gas supply line.
2. Make sure the cable coming from the power
supply (opposite the power cord that connects
to the wall) is connected to the Power Input
connector on the back of the unit. Also, check
to make sure that both of the micro-switches
located on the back of the unit are in the up
position.
3. Plug the power cord (provided) into the power
plug on the power supply (black rectangular
box) mounted on the back of the wine dispens-
ing system.
4. Slowly and gently lift the unit up and into the
final location. Exercise care to make sure that
the power cord and gas lines do not become
kinked or damaged. Make sure the required 1"
(2.5 cm) space is maintained above and below
the unit.
Setting Up Your Wine Dispensing System
Connect power
supply output
here
120 Vac
power cord
Connect to 120 Vac, 60 Hz.
electrical outlet
Power
supply
Plastic gas
tubing
These connectors
for use by qualified
service personnel only
Inert gas
connector
5. Open the door on the front of the unit. Swing the
spout cover to the up position as shown on the
facing page.
6. Make sure the power switch, located on the left
side of the bottle bay, is slid all the way down, to
the OFF position.
7. Lower the spout cover by pushing up and hold-
ing the lever on the bottom as you lower it
down. See diagram on bottom of page 8.
CAUTION: Do not push down on the spout
cover without pushing up on the lever. Damage
to the lever will result.
8. Once the spout cover is closed, close the bottle
bay door. Push in slightly just above the lock
until it snaps shut.
continued...
ON
OFF
Loading ...
Loading ...
Loading ...