Loading ...
Loading ...
Loading ...
using SPEAKERS on the front panel of the receiver. Make sure that the receiver outputs
sound and then try calibrating again.
Code 32, Code 33:
Sound is not detected from speakers.
Sound is not detected from one or both of the front
speakers. Ensure the calibration
microphone is not damaged, and is connected to the
CALIBRATION MIC jack on the
front panel of the receiver, and that all speakers are properly connected.
Sound is not detected from either the left or right surround speakers. Ensure both the
surround speakers are connected to the SURROUND terminals.
A surround back speaker is connected only to the SURROUND BACK/HEIGHT R
terminals. If connecting only one surround back speaker, connect it to the
SURROUND BACK/HEIGHT L terminals.
Sound is not detected from either the left or right height speakers. Ensure both the
height speakers are connected to the SURROUND BACK/HEIGHT terminals.
Sound is not detected from any speakers. Please ensure the calibration microphone is
not damaged and its plug is inserted all the way into the CALIBRATION MIC jack on the
front panel of the receiver.
Code 34:
The speakers are not placed in the proper positions. The left and right speakers or the left
and right sides of the calibration microphone may be switched.
Code 35:
The speaker pattern configuration does not match calibration result. Please check the
speaker pattern and connection.
Warning 40:
The measurement has been completed, but the noise level is high. For best results,
calibrate in as quiet a place as possible.
Warning 41, Warning 42:
The input signal from the calibration microphone is too large. The microphone may be too
close to the speakers. Please place the calibration microphone at your desired listening
position. Please note, when using the receiver as a pre-amplifier, this message may appear
by mistake. Please disregard.
Warning 43:
The distance and phase of the subwoofer cannot be detected. Please check the subwoofer
and re-calibrate in a quiet environment.
Warning 44:
The measurement has been completed, but the speaker may need to be re-positioned.
[229] Troubleshooting
General
The receiver is turned off automatically.
[Auto Standby] is set to [On] in the [System Settings] menu.
The sleep timer function was activated.
[PROTECTOR] was activated.
[230] Troubleshooting
General
Cannot find an available input when connecting
several digital devices.
Loading ...
Loading ...
Loading ...