Loading ...
Loading ...
Loading ...
©
2020 DJI All Rights Reserved.
51
DJI Assistant 2 for MG
Configure settings of the basic parameters, copy flight records, and update aircraft and remote
controller rmware in DJI Assistant 2 for MG.
Installation and Launching
1. Download the DJI Assistant 2 for MG installation le from the T20 download page:
http://www.dji.com/t20/info#downloads
2. Install the software.
3. Launch DJI Assistant 2 for MG.
Using DJI Assistant 2 for MG
Connecting the Aircraft
Connect the USB-C port on the bottom of the aerial-electronics system of the aircraft to a computer with
a USB-C cable, and then power on the aircraft.
Make sure to remove the propellers before using DJI Assistant 2 for MG.
Remove the waterproof cover on the USB-C port before use. Attach the waterproof cover to the
port after use. Otherwise, water may enter the port, causing it to short circuit.
Firmware Update
A DJI account is required for rmware updates. Login or register an account.
Basic Settings
Congure the idle speed of and test the motor.
Tools
Enter SD card mode and copy the ight record.
Connecting the Remote Controller
1. Connect the USB-C port of the remote controller to a computer with a USB A to A cable, and then
power on the remote controller.
2. Swipe from the top of the screen, and make sure that the USB option is enabled.
Firmware Update
A DJI account is required for rmware updates. Login or register an account.
DO NOT power off the remote controller during the update.
DO NOT perform the rmware update while the aircraft is in the air. Only carry out the rmware
update when the aircraft is on the ground.
The remote controller may become unlinked from the aircraft after the rmware update. Relink
the remote controller and aircraft if necessary.
Data Copy
To copy data, access the internal storage of the remote controller and the inserted microSD
card through the computer.
Loading ...
Loading ...
Loading ...