Loading ...
Loading ...
Loading ...
Communications and multimedia
●
A list of devices found is displayed on the
mobile phone. From this list, select the de-
vice
SEAT_BT
.
●
Ne
xt, accept the connection instructions on
the mobile phone.
●
When requested, follow the steps to con-
firm/enter the PIN. If the mobile requests a
PIN to be entered this is 1234, which is the
factory setting and can only be changed at
the workshop. Depending on the technology
supported by your mobile the process can
vary given that some mobiles only request
confirmation of a request to link to SEAT_BT,
while others require the PIN 1234 to be en-
tered.
●
The contacts from the mobile phone's
memory and/or SIM card are transferred to
the vehicle system
1)
. Some mobile phones
may display a message asking for confirma-
tion of access to the phone book or other op-
tions, these messages should be accepted in
order for the hands free system to access the
information contained on the mobile and in
order to carry out the complete functions of
the system.
●
The pairing is complete.
Automatic pairing
When the telephone has been connected and
the corresponding user profile created, your
telephone will automatically link up with the
SEAT telephone system under the following
conditions:
●
The mobile phone is switched on with the
Bluetooth function activated and the visibility
activated. The mobile phone must be close to
the vehicle.
●
The vehicle system has switched on Blue-
tooth visibility (it will be on for 3 minutes fol-
lowing activation of the contact or after
pressing the button “PTT”).
●
The automatic connection was accepted
during the questions of the first connection.
●
The connection to the system has not been
deleted in the mobile.
With the ignition switched on, the system
searches in the memorised Bluetooth devices
(user profiles), and if one of these devices is
found a connection attempt is made to con-
nect to the last linked profile that meets the
previously mentioned requirements. The sys-
tem will continue connection attempts while
there is no connected device.
When a Bluetooth device is connected or
when the automatic connection conditions
are met, in order to connect another Blue-
tooth device, an existing connection or one
that is in the process being connected must
be deactivated in advance. In order to do
this, deactivate the Bluetooth on the unwan-
ted device.
Note
●
The visibility of the vehicle's Bluetooth sys-
tem is switched on for three minutes when
the ignition is switched on with the key. After
3 minutes, if you need to activate the visibili-
ty again, you can do so with the voice control
››› page 76 or turning the ignition off and on
again.
●
If
for any reason you take more than 3 mi-
nutes to perform these steps or more than 30
seconds to enter the PIN, you will have to
start the process over again.
Controls on the multifunction control
Fig. 80 Multifunction control buttons.
»
1)
Depending on the phone model and configuration.
75
Technical specifications
AdviceOperationSafetyThe essentials
Loading ...
Loading ...
Loading ...