Loading ...
Loading ...
Loading ...
Advice
Removing
–
Remove the wheel cover using the wire
hook ››› Fig. 158
.
–
Hook
thi
s into one of the cut-outs of the
wheel cover.
Fitting
–
Fit the wheel cover onto the wheel rim by
pressing it firmly. Put pressure initially on
the point of the cut-out for the valve. Next
fit the rest of the hubcap
Loosening the wheel bolts
Fig. 159 Changing a wheel: loosen the wheel
bolts.
The wheel bolts must be loosened before
raising the vehicle.
Loosening
–
Fit the box spanner as far as it will go over
the wheel bolt.
–
Grasp the box spanner by the end turn it
about one full turn to the left
›
›› Fig. 159
.
Tightening
–
Fit the box spanner as far as it will go over
the wheel bolt.
–
Grasp the box spanner close to the end and
turn the bolt to the right until it is secured.
–
An adapter is required to unscrew or tight-
en the anti-theft wheel bolts.
WARNING
Loosen the wheel bolts (only about one turn)
before raising the vehicle with the jack, oth-
erwise there is a risk of accident.
Note
●
If the wheel bolt is very tight, you may be
able to loosen it by pushing the end of the
spanner down carefully with your foot. Hold
on to the vehicle for support and take care
not to slip.
Raising the vehicle
Fig. 160 Jack position points
Fig. 161 Fitting the jack.
Read the additional information carefully
›››
page 27
In order to remove the wheel, the vehicle
must be raised with a jack.
–
Locate the jacking point under the door sill
closest to the punctured wheel ››› Fig. 160
.
184
Loading ...
Loading ...
Loading ...