Loading ...
Loading ...
Loading ...
Operation
Priority 2 warning messages will not be
shown until all Priority 1 warning messages
have been dealt with!
Examples of priority 2 warning reports
(yellow):*
●
Fuel warning light with the information text
PLEASE REFUEL.
Information messages displayed on
the screen*
Messages
a)
Description
SERVICE
The service interval has ended. Take
the vehicle to a Technical Service.
IMMOBILISER
Immobiliser system active. The vehicle
will not start. Take the vehicle to a
Technical Service.
ERROR
Instrument panel faulty. Take the vehi-
cle to a Technical Service.
CLEAN AIR FIL-
TER
Warning: Clean the air filter.
NO KEY
Warning: Correct key cannot be found
in the vehicle.
KEY BATTERY
Warning: Key battery low. Change the
battery.
CLUTCH
Warning: Press the clutch to start. In
vehicles with manual gearbox and
Start-Stop system.
Messages
a)
Description
--> P/N
Warning: Place the selector level in
position P/N to start. Only in vehicles
with automatic gearbox.
--> P
Warning: Place the selector lever in
position P to stop the engine.
STARTING
Warning: The engine starts automati-
cally. Start-Stop system activated.
START MAN-
UALLY
Warning: The engine must be started
manually. Start-Stop system activated.
ERROR START-
STOP
Warning: Start-Stop system error.
START-STOP
IMPOSSIBLE
Warning: Although the Start-Stop sys-
tem is switched on, the engine cannot
be stopped automatically. Not all the
necessary conditions are met.
START-STOP
ACTIVE
Warning: Start-Stop system activated.
Vehicle in Stop mode.
SWITCH OFF
Warning: Start-Stop system activated.
Switch off the ignition when you leave
the vehicle.
STOP TRANS-
MISSION TOO
HOT
Warning: Stop the engine. Gearbox
overheated.
BRAKE
Warning: To start the engine, press the
brake pedal. Only in vehicles with au-
tomatic gearbox.
COASTING
FUNCTION
Warning: “Coasting” mode active.
Transmission engaged. Only in vehi-
cles with automatic gearbox.
Messages
a)
Description
CHECK SAFE-
LOCK
Notification of central locking function
activated.
a)
These messages may vary according the version of the vehi-
cle model.
Engine management*
This warning lamp monitors the engine man-
agement system for petrol engines.
The warning lamp (Electronic Power Con-
trol) lights up when the ignition is switched
on while system operation is being verified. It
should go out once the engine is started.
If there is a fault in the electronic engine
management system while you are driving,
this warning lamp will light up. Stop the vehi-
cle and seek technical assistance.
Glow plug system/Engine fault*
The warning lamp lights up to show that the
glow plugs are preheating the diesel engine.
The control lamp lights up
If the control lamp lights up when the en-
gine is started it means that the glow plugs
are preheating. When the warning lamp goes
off, the engine should be started straight
away.
58
Loading ...
Loading ...
Loading ...