Loading ...
Loading ...
Loading ...
Opening and Closing
Press down on a switch to lower the associated window.
Window switches operate at two levels:
• To lower a window fully, press the switch all the way
down and immediately release.
• To lower a window partially, press the switch gently
and release when the window is where you want it.
Similarly, pull a switch to raise the associated window:
•
To raise a window fully, pull the switch all the way up
and immediately release.
•
To raise a window partially, pull the switch gently
and release when the window is where you want it.
NOTE: See Cold Weather Best Practices on page 77
for information on preparing windows for cold weather.
CAUTION:
When exiting the vehicle, be careful
not to unintentionally press the window switches,
as they may lower the windows on the driver or
other doors.
CAUTION:
Closing the door while the window is
fully raised (for example, if manually raised) can
damage the windows or the vehicle. Ensure the
window is slightly lowered before closing the
door.
WARNING:
Before closing a window, it is the
driver’s responsibility to ensure that all occupants,
especially children, do not have any body parts
extended through the window’s opening. Failure
to do so can cause serious injury.
Locking Rear Windows
To prevent passengers from using the rear window
switches, touch
Controls > Quick Controls > Window
Lock. To unlock the rear windows, touch Window Lock
again.
WARNING: To ensure safety, it is recommended
that you lock the rear window switches whenever
children are seated in the rear seats.
WARNING: Never leave children unattended in
Model 3.
Calibrating Windows
In the unlikely event that a window behaves
unexpectedly (touches the bright molding, fails to open
or close properly, goes down more than normal when
the door opens, etc.), you can calibrate it to potentially
fix the issue.
To calibrate a window:
1.
Close the door with the aected window.
2.
Sit in the driver's seat and close the driver door.
3.
Use the driver window switch to raise the aected
window until it stalls.
4.
Use the driver window switch to lower the aected
window until it stalls.
5.
Use the driver window switch to raise the aected
window until it stalls.
The window should now be calibrated. If the issue
continues after attempting the calibration procedure a
couple times, contact Tesla.
Windows
15Opening and Closing
Loading ...
Loading ...
Loading ...