Loading ...
Loading ...
Loading ...
Operating Seat Heaters
To control the front seat heaters for the driver and
passenger, touch the corresponding control on the main
climate control area at the bottom of the touchscreen.
To control the rear seat heaters (if equipped) or access
duplicate controls for the front seat heaters, touch the
fan icon, then touch the seat heater icon followed by the
seat for which you want to adjust heating. Seat heaters
operate at three setting levels from 3 (highest) to 1
(lowest). When operating, the associated seat icon
displays twisting lines that turn red to indicate the
setting level. You can touch
All O to turn o all seat
heaters simultaneously.
Adjusting the Front Vents
Model 3 has a unique horizontal face-level vent that
spans the width of the dashboard. Using the
touchscreen, you can pinpoint exactly where you want
to direct the air
flowing from this vent when heating or
cooling the front cabin area.
1.
Driver vent and controls
2.
Passenger vent and controls
When the face-level vent is on you can adjust the
direction of the air flow from each vent. To adjust the
direction of the air
flow, simply touch the radiating air
waves from the corresponding vent on the touchscreen.
The air flows in a single stream when centered or splits
into mirrored air streams when air is directed outward or
inward from the center of the vent.
NOTE: When you split a vent into two separate air flows,
the air flow in each direction is not as strong as when all
air is flowing in a single direction.
NOTE: Outside air is drawn into Model 3 through the grill
in front of the windshield. Keep the grill clear of
obstructions, such as leaves and snow.
Adjusting the Rear Vents
Model 3 has vents located at the back of the center
console where air
flows from when the setting is turned
on from the touchscreen. To direct the flow of air in the
rear cabin area, adjust the vents at the rear of the center
console up, down, or from side to side as necessary.
Climate Controls
126 MODEL 3 OWNER'S MANUAL
Loading ...
Loading ...
Loading ...