Loading ...
Loading ...
Loading ...
Driving
●
V
ehicles travelling in the opposite direction
or crossing the road.
●
Other stationary obstacles
The ACC does not react to stationary vehi-
cles. If, for example, a vehicle detected by the
ACC turns or moves over and there is a sta-
tionary vehicle in front of it, the ACC will not
react to the second vehicle
›››
Fig. 156 .
WARNING
Using the ACC in the above situations can
cause serious accidents and injuries, and
you coul
d break the law.
Problems and solutions
ACC not available
The indicat
or lamp lights up yellow:
●
The radar sensor is dirty or adjusted incor-
rectly. Take into account the warnings descri-
bed in this section
›››
page 212
●
There is a fault or defect. Turn off the vehi-
cle's ignition and turn it on again after a few
minutes.
●
If the problem persists, consult a special-
ised workshop.
The ACC does not work as expected
●
Make sure that the conditions are met for
the radar sensor to operate properly
›››
page 212.
●
If the brakes overheat, regulation stops au-
tomatically. Wait for them to cool down and
check the operation again.
●
Unusual noises during automatic ACC
braking are normal and do not indicate any
anomalies.
The following conditions may lead the
ACC not to react:
●
The accelerator or brake is depressed.
●
No gear is engaged or the vehicle is in gear
R.
●
The vehicle is reversing.
●
ESC is operating.
●
The driver is not wearing his/her seat belt.
●
A vehicle or trailer brake light is faulty.
●
The RPM is too high or too low.
●
The parking brake is applied.
●
Driving on an excessive slope.
Lane Assist
Introduction
The Lane Assist System helps the driver
st
ay in his/her lane within the physical lim-
its of the system. This function is not suita-
ble and is not designed to keep the vehicle
automatically in the lane.
Using the camera located in the windscreen,
the Lane Assist system detects the limits (lane
lines) dividing the lanes in which the vehicle is
travelling. If the vehicle gets too close to the
detected lane limits, the system alerts the
driver through a corrective motion of the
steering wheel. The driver can cancel the
steering corrective action at any time.
No warning is produced with the turn signals
activated, given that the Lane Assist system
understands that a lane change is required.
System limits
Use the Lane Assist system only on large,
well-maintained motorways and highways.
The system is not available under the follow-
ing conditions:
●
The driving speed allowed is below approx.
55 km/h (30 mph).
●
The system has not detected any lane
lines.
226
Loading ...
Loading ...
Loading ...