Loading ...
Loading ...
Loading ...
Practical tips
●
Open the door and pull the l
ever under the
dashboard
›››
Fig. 161
1
.
●
Lift the bonnet up slightly while pressing the
r
elease lever
›››
Fig. 161
2
in the direction of
the arr
ow to completely open the bonnet.
●
Take out the bonnet support rod from its
clip in the direction of the arrow
›››
Fig. 162
3
and place it in the corresponding open posi-
tion
4
(arrow).
Cl
osing the bonnet
●
Slightly lift the bonnet.
●
Release the bonnet stay and replace it in its
support.
●
At a height of approximately 20 cm let it fall
so it locks.
If the bonnet does not close, do not press
downwards. Open it again and let it fall as
mentioned above.
WARNING
If the bonnet is not properly closed, it could
open une
xpectedly while in motion and im-
pede forward visibility. This could cause
accidents and lead to serious injuries.
●
After closing the bonnet, ensure that the
lock is duly engaged in the lock carrier. The
bonnet must be at the same level as the
adjacent parts of the bodywork.
●
If whil
e in motion you notice the bonnet is
not properly closed, stop the vehicle imme-
diately and close the bonnet.
●
Open and close the bonnet only when
there is nobody in its path.
CAUTION
●
T
o avoid damage to the bonnet and to the
wiper arms, open the bonnet only when the
wiper is disconnected and the wiper arms
are positioned on the windscreen.
●
Before starting to move, always place the
wiper arms on the windscreen.
Cooling system
Contr
ol lamp
Flashes red
Excessive engine coolant temperature.
St
op the vehicle! Stop the vehicle safely as soon
as possible. Disconnect the drive system and allow to
cool until the lamp switches off. If the lamp does not
switch off once the drive system has cooled down,
seek specialist assistance.
Insufficient engine coolant level.
St
op the vehicle! Check the coolant level once
the drive system has cooled down and, if it is low, re-
fill with engine coolant
›››
page 181.
Flashing red next to the dis-
pl
ay --.- on the instrument
panel.
Engine coolant system faulty.
St
op the vehicle! Seek specialist assistance.
Several control and warning lamps light up
f
or a few seconds when the ignition is switch-
ed on while the function is verified. They will
switch off after a few seconds.
WARNING
Observe the safety warnings
›
››
in Con-
tr
ol and warning lamps on page 66.
Coolant specifications
The engine cooling system is supplied from
the f
actory with a specially treated mixture of
water and at least 40 % of the additive
G12evo (TL-VW 774 J), purple. This mixture
gives the necessary frost protection down to
-25°C (-13°F) and protects the light alloy
parts of the engine cooling system against
corrosion. It also prevents scaling and con-
siderably raises the boiling point of the cool-
ant.
To protect the cooling system, the percent-
age of additive must always be at least 40 %,
even in warm climates where anti-freeze pro-
tection is not required.
180
Loading ...
Loading ...
Loading ...