Loading ...
Loading ...
Loading ...
Introduction
General instructions for use
Additional instructions
Depending on the vehicle, notifications of the
f
actory-fitted driving assistance systems are
shown on the display. The notifications close
automatically when they are no longer use-
ful.
All notifications are only displayed after com-
pletely resetting the radio system.
Note
●
Pushing the butt
ons gently is enough to
use the equipment.
●
Due to country-specific legislation, cer-
tain functions may not be available when
the vehicle is travelling above a certain
speed.
●
Using a mobile telephone inside the vehi-
cle may cause noise in the speakers.
●
On some vehicles with ParkPilot, the vol-
ume of the active audio source is automati-
cally lowered when reverse gear is selec-
ted.
Rotary push buttons, equipment
and function butt
ons
Overview
●
Rotary push buttons.
●
Equipment buttons named (physical but
-
tons).
●
Function buttons (virtual buttons).
Rotary push buttons
The left-hand rotary push button is known
as volume control or the on/off button.
The right-hand rotary push button is known
as the settings button.
Equipment buttons and function buttons
The named buttons of the equipment are
known as “equipment buttons” and are
shown with a button symbol inside a rectan-
gle, for instance, equipment button
.
Unnamed equipment butt
ons are located be-
low the display. These equipment buttons are
known as “function buttons” as their purpose
depends on the active function mode.
The function assigned to a function button is
explained on the bottom of the display,
above the corresponding button.
Switching on and off
●
To manually switch the system on and off,
briefly pr
ess the rotary push button .
When the unit is switched on the system
starts up. The last active audio source will be
played with the set volume, as long as this
does not exceed the maximum, predefined
“switch-on” volume ( Volume
).
Depending on the equipment and country,
when s
witching off the engine or removing
the key from the ignition, the system switches
off automatically. If the system is switched on
again without switching on the ignition, it will
switch off automatically after approximately
30 minutes (switch-off delay).
Energy management
If the charge of the battery goes below the
minimum onboard charge with the ignition
switched off and the system active, an audi-
ble warning will be emitted and the LOW BAT-
TERY message will be displayed. If this hap-
pens, you should turn off the equipment.
Anti-theft password
The password of the anti-theft coding system
is stored in the system after entering it for the
first time (radio convenience coding). If you
have to enter the anti-theft password man-
ually, for instance, because the system has
»
111
Loading ...
Loading ...
Loading ...