Loading ...
Loading ...
Loading ...
High-voltage battery
●
Unplug the char
ging cable from the power
supply source.
●
If available, replace the protective caps.
●
Close the cover of the battery charging
socket until you hear it has engaged.
Charging for the first time and charging
after not being used for a long period of
time
When the high-voltage battery is new or has
not been charged for a long period of time, it
is possible that the battery may not reach its
maximum charge level until it is charged sev-
eral times. This is due to technical reasons
and has nothing to do with any fault in the ve-
hicle.
If you are not going to use the vehicle for a
long period of time, make sure you charge the
high-voltage battery within a period of 4
months at the latest.
Note
If once the charge is completed you leave
the char
ging cable connected, the high-
voltage battery will not discharge due to
the use of the vehicle’s electricity consum-
ers.
Fast charge at a charging station
(CC)
Fig. 153
Behind the cover of the battery charg-
ing sock
et: charging socket (schematic repre-
sentation).
Key to
›
››
Fig. 153
Charging process display
Charging socket
Protective caps
Depending on the equipment, the vehicle can
be charged with direct current (DC) at a
charging station.
Take into account the general information re-
lating to charging the high-voltage battery
and the preparations to be carried out before
charging
›››
page 159.
Before charging the battery, always discon-
nect the drive system
›››
page 137.
1
2
3
Connecting the charging cable
F
ast charge is carried out through the con-
nection located at the bottom of the charging
socket.
●
Remove the charging cable from the
charging station.
●
With the vehicle unlocked, press the cover
of the battery charging socket, located on
the side panel, to open it
›››
Fig. 153.
●
Remove the two protective caps from the
charging socket
›››
Fig. 153
3
. To remove the
bott
om protective cap, first remove the top
cap.
●
Plug the charging connector into the
charging socket
›››
Fig. 153
2
.
As soon as the connect
or is detected, the
charging process display lights up yellow.
The charging connector is locked. The con-
trol lamp is on in the instrument panel dis-
play.
Automatic start of the charging process
In this case, activate the charging station
›››
.
The char
ging process will start immediately.
During the charging, the charging connector
remains locked and cannot be removed from
the charging socket.
»
167
Loading ...
Loading ...
Loading ...