User Manual - Page 141

For MII ELECTRIC 2021.

Loading ...
Loading ...
Loading ...
Drive system and driving
A short sequence of acoustic signals indi-
cat
es that the drive system has been
reconnected.
If 30 seconds elapse without the drive system
being reconnected, the drive system can be
reconnected manually as described in
page 136. In this case, bear in mind the
messages shown on the instrument panel
display.
WARNING
If the vehicle is left unattended with the
driv
e system connected, accidents and se-
rious injuries can occur.
Never leave the vehicle unattended with
the drive system connected.
Always switch off the ignition and place
the selector lever in position P before leav-
ing the vehicle.
When parking or getting out of the vehi-
cle, always check that the selector lever is
in the P position and that the handbrake is
applied and tightened.
When leaving the vehicle, always make
sure that all the doors, the windows, the
rear lid and the bonnet are completely
closed and locked.
Electronic immobilizer
The electronic immobiliser helps to prevent
the driv
e system from being connected with
an unauthorised key and, consequently, the
vehicle being put in motion.
The vehicle key has a built-in chip. When a
valid key is inserted into the ignition lock, the
chip automatically deactivates the electronic
immobiliser.
The electronic immobiliser will be activated
again automatically as soon as you pull the
key out of the ignition lock.
For this reason, the vehicle's drive system can
only be connected with a properly coded
Original SEAT key. This type of keys can be
purchased from a SEAT dealer.
Note
The correct operation of the vehicle is only
guar
anteed with the original SEAT keys.
e-Sound
e-Sound is an electric engine noise that
w
arns other road users that an electric vehi-
cle is approaching.
e-Sound turns on after the drive system is
switched on.
The e-Sound gradually fades as the vehicle
accelerates.
Problems and solutions
Cannot remove the vehicle key from the
ignition l
ock
An unauthorised key has been inserted into
the ignition lock.
To remove the key, proceed as follows:
Press the lock key on the selector lever and
release it again.
Remove the key from the ignition switch.
The drive system cannot be connected
If an unauthorised vehicle key is used or there
is a fault in the system, an indication appears
on the instrument panel display.
Use an authorised key.
If the fault continues, seek specialist assis-
t
ance.
The vehicle has stopped because the
high-voltage battery has discharged
The relevant text message will appear in the
instrument panel display.
If the vehicle has stopped because the high-
voltage battery has discharged, there is the
possibility of reconnecting the electric drive
system to travel a few meters and be able to
remove the vehicle from the flow of traffic or
from a level crossing, etc.
»
139
Loading ...
Loading ...
Loading ...