Loading ...
Loading ...
Loading ...
N3
User Manual
20
©
2016 DJI All Rights Reserved.
When to Recalibrate
1. When compass data is abnormal, and the Aircraft Status Indicator is
blinking red and yellow.
2. When ying in a new location, or a location that is dierent from your last
ight.
3. When the mechanical structure of the N3 has changed, i.e. the mounting
position of the compass has changed.
4. When severe drifting occurs in ight, i.e. the N3 does not y in a straight line.
Flight Functions
Flight Modes
P-mode is preferred for most ying scenarios. Users can switch to Atti mode where and when
P-mode is unavailable. Be aware that some features are NOT available in Atti mode, and take
EXTRA caution when ying in Atti mode.
1. P-mode (Positioning): P-mode works best when the GNSS signal is strong. There are three
dierent states of P-mode, which will be automatically selected by the ight control system
depending on GNSS signal strength and Vision Positioning sensors:
a. P-GPS: GNSS and Vision Positioning are both available, and the aircraft is using GNSS for
positioning.
b. P-OPTI*: If GNSS is NOT available, the aircraft will use the Vision Positioning System to hover
accurately.
c. P-ATTI: When neither GNSS nor Vision Positioning is available, the aircraft is using only its
barometer for positioning, so only altitude is controlled.
2. Atti mode (Attitude): The GNSS and Vision Positioning System are NOT used for positioning.
The aircraft only uses its barometer to maintain altitude. If it is still receiving a GNSS signal, the
aircraft can automatically return home if the Remote Controller signal is lost and if the Home
Point has been recorded successfully.
3. S-mode (Sports): S-mode is identical to P-mode in terms of ight controller settings, except that
the handling gain values of the aircraft are adjusted in order to enhance the maneuverability of
the aircraft. The maximum ight speed of the aircraft is increased in this mode.
4. Manual mode: Only use it in emergency situations.
Using DJI GO (Lightbridge 2 is required):
Tap the Aircraft Status Indicator bar in the DJI GO app and select “Calibrate”, then follow the on-
screen instructions.
If the Aircraft Status Indicator blinks red and yellow after the calibration, move your
aircraft to a dierent location to carry out compass calibration.
Calibrate the compass before each ight. Launch DJI GO App, follow the on-screen
instructions to calibrate the compass.
Loading ...
Loading ...
Loading ...