Dji N3 User Manual - Page 18/40

Loading ...

User Manual

DJI

Assistant 2

Ensure the ight control system is properly powered on.

Connect the Micro USB port on the LED module to a PC via a Micro USB cable.

Run DJI Assistant 2. Note that you may be asked to register for rst time use.

Follow the prompts to upgrade the rmware to the latest version*.

Select the airframe type.

Congure the Flight Controller, IMU and GNSS-Compass mounting parameters.

1 2 34

API Pin Descriptions

1. Power pin: Supply voltage of 9 V and power consumption of 9 W. If the API device does not

satisfy the above voltage and consumption requirements, provide an alternate power supply.

2. GND pin: Connects to the API device’s GND (ground) pin.

3. UART-TXD pin: Serial signal pin with voltage level of 3.3 V, should be connected to the API

device’s RXD pin.

4. UART-RXD pin: Serial signal pin with voltage level of 3.3 V, should be connected to the API

device’s TXD pin.

ParameterConguration

Watch the video tutorial for a brief introduction on how to congure the parameters. Then launch

DJI Assistant 2 and follow the prompts to complete conguration.

*PleasenotethatrmwareupdatemayresetvariousMainControllerSettings,suchastheRTHAltitudeand

MaximumFlightDistance,tofactorydefaults.Beforetheupdate,takenoteofyourpreferredsettings,andreadjust

themaftertheupdatetosuityourpreference.

Loading ...

Dji N3 Flight Controller