Loading ...
Loading ...
Loading ...
272
In the event of a breakdown
Checking / adjusting tyre
pressures
You can also use the compressor,
without injecting sealant, to check and, if
necessary, adjust the tyre pressures
F Remove the valve cap from the tyre and
place it in a clean area.
F Uncoil the pipe stowed under the
compressor.
F Check that the compressor switch is at
the "O" position.
F Uncoil fully the electric cable, stowed under
the compressor.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-inflation detection system.
For more information on Under-inflation
detection, refer to the corresponding
section.
The tyre inflation pressures are given on
this label.
F Screw the pipe onto the valve and tighten
firmly.
F Connect the compressor's electrical
connector to the vehicle's 12 V socket.
F Switch on the ignition.
F Start the compressor by placing the switch
at the "I" position and adjust the pressure
to the value shown on the vehicle's tyre
pressure label. To deflate: press the black
button located on the compressor pipe, near
the valve connection.
F Once the correct pressure is reached, put
the switch to the "O" position.
F Remove the kit then stow it.
Loading ...
Loading ...
Loading ...