Owner’s Manual - Page 261

For MII 2012.

Loading ...
Loading ...
Loading ...
259Practical information
Start the vehicle engine and leave it running.
Attach the connector ⇒ Fig. 146
9
to a 12 volt socket of the vehicle
⇒ page 117.
Connect the air compressor with the ON/OFF switch ⇒ Fig. 146
8
.
Keep the air compressor running until it reaches 2.0 to 2.5 bar
(29-36 psi / 200-250 kPa) ⇒ 
. Maximum operation time 8 minutes ⇒  .
Disconnect the air compressor.
If it is not possible to achieve an air pressure of 2.0 to 2.5 bar
(29-36 psi / 200-250 kPa), unscrew the tyre inflator tube from the tyre valve.
Move the vehicle some 10 metres forwards or backwards so that the
sealant is evenly distributed in the tyre interior.
Securely screw the compressor tyre inflator tube into the tyre valve and
repeat the inflation process.
If the indicated pressure can still not be reached, the tyre is too badly
damaged. The tyre cannot be sealed with the anti-puncture kit. Do not con-
tinue driving. You should obtain professional assistance ⇒ 
.
Disconnect the air compressor and unscrew the flexible inflator tube
from the tyre valve.
When the tyre pressure is between 2.5 and 2.0 bars, immediately con-
tinue driving without exceeding 80 km/h (50 mph).
After 10 minutes, Check the pressure again ⇒ page 259.
WARNING
When inflating the wheel, the air compressor and the inflator tube may
become hot.
Protect hands and skin from hot parts.
Do not place the hot flexible inflator tube or hot air compressor on
flammable material.
WARNING (Continued)
Allow them to cool before storing the device.
If it is not possible to inflate the tyre to at least 2.0 bars (29 psi /
200 kPa), the tyre is too badly damaged. The sealant is not in a good con-
dition to seal the tyre. Do not continue driving. You should obtain profes-
sional assistance.
CAUTION
Switch off the air compressor after a maximum of 8 operational minutes to
avoid overheating! Before switching on the air compressor again, let it cool
for several minutes.
Check after 10 minutes of driving
Screw the inflator tube ⇒ Fig. 146
5
again and check the pressure on the
gauge
6
.
1.3 bar (19 psi / 130 kPa) and lower:
Stop the vehicle! The tyre cannot be sealed sufficiently with the tyre mo-
bility set.
You should obtain professional assistance ⇒ 
.
1.4 bar (20 psi / 140 kPa) and higher:
Set the tyre pressure to the correct value again ⇒ page 210.
Carefully resume your journey until you reach the nearest specialised
workshop without exceeding 80 km/h (50 mph).
Have the damaged tyre replaced.
Vehicle diagram Prior to a journey... While driving Care, cleaning and mainte-
nance
If and when Technical Data
Loading ...
Loading ...
Loading ...