Loading ...
Loading ...
Loading ...
Problem Possible cause Remedy
comes on.
There is an error in the hob
because a cookware
boiled dry. Automatic
Switch Off and the over‐
heating protection for the
zones operate.
Deactivate the hob. Re‐
move the hot cookware.
After approximately 30
seconds, activate the zone
again. If the cookware was
the problem, the error mes‐
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati‐
ble with the hob.
Refer to “Hints and tips”
chapter.
The oven does not heat
up.
The oven is deactivated. Activate the oven.
The necessary settings are
not set.
Make sure that the settings
are correct.
The clock is not set. Set the clock.
The lamp does not oper‐
ate.
The lamp is defective. Replace the lamp.
Steam and condensation
settle on the food and in
the cavity of the oven.
You left the dish in the
oven for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
It takes too long to cook
the dishes or they cook too
quickly.
The temperature is too low
or too high.
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
The display shows an error
code that is not in this ta‐
ble.
There is an electrical fault. Deactivate the appliance
with the house fuse or the
safety switch in the fuse
box and activate it again.
If the display shows the er‐
ror code again, contact the
Customer Care Depart‐
ment.
The display shows "12.00". There was a power cut. Reset the clock.
You cannot activate or op‐
erate the oven. The display
shows “400” and an acous‐
tic signal sounds.
The oven is incorrectly
connected to an electrical
supply.
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
ENGLISH 31
Loading ...
Loading ...
Loading ...