Loading ...
Loading ...
Loading ...
Remote Operation
Remote Command Summary16
16-25
LOCKMODE <cpd> Set the channel lock mode to <INDEP>,
<MASTER>, <FTRACK> or <SLAVE>.
LOCKSTAT <cpd> Set the channel lock status to <ON> or
<OFF>.
LOCAL Returns the instrument to local operation
and unlocks the keyboard. Will not
function if LLO is in force.
LRN <character data> Install data for a previous
*
LRN?
command.
MOD <cpd> Set the modulation source to <OFF>,
<EXT> or <PREV>.
MODE <cpd> Set the mode to <CONT>, <GATE>,
<TRIG>, <SWEEP> or <TONE>.
MODTYPE <cpd> Set the modulation type to <AM> or
<SCM>.
OUTPUT <cpd> Set the main output <ON>, <OFF>,
<NORMAL> or <INVERT>.
PHASE <nrf> Set the slave generator phase to <nrf>
degrees.
POSNMKRCLR <cpd> Clear all position markers from arbitrary
waveform <cpd>.
POSNMKRPAT <cpd1>,<nrf1>,
<nrf2>,<cpd2>
Put the pattern <cpd2> into the arbitrary
waveform <cpd1> from start address
<nrf1> to stop address <nrf2>.
POSNMKRRES <cpd>,<nrf> Clear the position marker at address
<nrf> in arbitrary waveform <cpd> to
0 (low).
POSNMKRSET <cpd>,<nrf> Set the position marker at address <nrf>
in arbitrary waveform <cpd> to 1
(high).
PULSDLY <nrf> Set the pulse delay to <nrf> sec.
PULSPER <nrf> Set the pulse period to <nrf> sec.
PULSWID <nrf> Set the pulse width to <nrf> sec.
PULTRNBASE <nrf> Set the pulse-train base line to <nrf>
Volts.
PULTRNDLY <nrf1>,<nrf2> Set the delay of pulse-train pulse number
<nrf1> to <nrf2> sec.
PULTRNLEN <nrf> Set the number of pulses in the pulse-train
to <nrf>.
PULTRNLEV <nrf1>,<nrf2> Set the level of pulse-train pulse number
<nrf1> to <nrf2> Volts.
PULTRNMAKE Make the pulse-train and run it - similar to
the WAVE PULSTRN command.
PULTRNPER <nrf> Set the pulse-train period to <nrf> sec.
PULTRNWID <nrf1>,<nrf2> Set the width of pulse-train pulse number
<nrf1> to <nrf2> sec.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...