Loading ...
Loading ...
Loading ...
User Guide 268
Configuring GVRP GVRP Configuration
Step 3 interface {fastEthernet
port
| range fastEthernet
port-list
| gigabitEthernet
port
| range
gigabitEthernet
port-list
| ten-gigabitEthernet
port
| range ten-gigabitEthernet
port-list
|
port-channel
port-channel-id
| range port-channel
port-channel-list
}
Enter interface configuration mode.
Step 4 gvrp
Enable GVRP on the port.
Step 5 gvrp registration { normal | fixed | forbidden }
Configure the GVRP registration mode for the port. By default, it is normal.
normal: In this mode, the port can dynamically register and deregister VLANs, and transmit
both dynamic and static VLAN registration information.
fixed: n this mode, the port is unable to dynamically register and deregister VLANs, and can
transmit only the static VLAN registration information.
forbidden: In this mode, the port is unable to dynamically register and deregister VLANs,
and can transmit only information of VLAN 1.
Step 6 gvrp timer { leaveall | join | leave }
value
Set the GARP timers according to your needs.
leaveall: When a GARP participant is enabled, the LeaveAll timer will be started. When the
LeaveAll timer expires, the GARP participant will send LeaveAll messages to request other
GARP participants to re-register all its attributes. After that, the participant restarts the
LeaveAll timer.
join: Join timer controls the sending of Join messages. A GVRP participant starts the Join
timer after sending the first Join message. If the participant does not receive any response,
it will send the second Join message when the Join timer expires to ensures that the Join
message can be sent to other participants.
leave: The Leave timer controls attribute deregistration. A participant will send a Leave
message if it wants other participants to deregister some of its attributes. The participant
receiving the message starts the Leave timer. If the participant does not receive any Join
message of the corresponding attribute before the Leave timer expires, the participant
deregisters the attribute.
value
: Set a value for the timer. It should be an integral multiple of 5. For LeaveAll timer,
the valid values are from 1000 to 30000 centiseconds and the default value is 1000
centiseconds. For Join timer, the valid values are from 20 to 1000 centiseconds and the
default value is 20 centiseconds. For Leave timer, the valid values are from 60 to 3000
centiseconds and the default value is 60 centiseconds.
Step 7 show gvrp global
Verify the global configurations of GVRP.
Step 8 show gvrp interface [ fastEthernet
port
| gigabitEthernet
port
| ten-gigabitEthernet
port
| port-channel
port-channel-id
]
Verify the GVRP configuration of the specified port or LAG.
Loading ...
Loading ...
Loading ...