Loading ...
Loading ...
Loading ...
Configuring sFlow (Only for Certain Devices) sFlow Configuration
User Guide 979
2.1.2 Configuring the sFlow Collector
Choose the menu MAINTENANCE > sFlow > sFlow Collector to load the following page.
Figure 2-2 Configuring the sFlow Collector
Follow these steps to configure the sFlow Collector:
1) Select a Collector and configure the relevant parameters.
Collector ID Displays the Collector ID. The switch supports 4 collectors at most.
Description Give the collector a description for identification with 16 characters at most.
Collector IP Enter the IP address of the host that runs the sFlow Collector.
Collector Port Specify the UDP port number for the sFlow collector. The default is port 6343.
Maximum
Datagram Size
Specify the maximum number of data bytes that can be sent in a single sample
datagram. Valid values are from 300 to 1400 bytes and the default is 300 bytes.
Timeout (s) Specify the aging time after which the sFlow Collector will become invalid. Valid
values are from 0 to 2000000 seconds; the default is 0, which means the collector
is always valid.
Lifetime (s) Displays the remaining time of the collector. Lifetime counts down from Timeout.
2) Click Apply.
2.1.3 Configuring the sFlow Sampler
An sFlow Sampler is a data source that collects flow samples. Usually the ports act as
sFlow Samplers.
Loading ...
Loading ...
Loading ...