Loading ...
Loading ...
Loading ...
11
SET-UP
1. Remove the four hex screws (a) from the bumper (b)
(Figure 15).
2. Position the bumper brackets to the inside of the tractor’s
frame and secure it in place with the four hex screws (a)
(Figure 15).
aa
b
Figure 15
Installing the FastAttach™ Brush Guard
(If equipped)
1. Align the brush guard assembly with the FastAttach™
brackets and push assembly together (Figure 16).
Figure 16
2. Install the pins on the right and left side of brush guard
(1) and then secure with two cotter pins (2) found in the
hardware pack (Figure 17).
NOTE: Pulling up lightly on the brush guard may make
installation of the pins easier.
1
2
Figure 17
Lower Deck Discharge Chute Deflector
WARNING
Never operate the mower deck without the chute
deflector installed and in the down position.
FOR 46 INCH DECK MODELS:
1. Remove the keys attached with a zip tie to the chute bracket.
2. Remove the flange lock nut and hex screw from the deck.
3. Place the chute deflector on the deck, be sure to insert
the tabs on the chute deflector into the holes on the deck
(Figure 18).
3
4
4
5
5
Figure 18
4. Slide the chute deflector toward the rear of the tractor until
the bolt hole in the chute deflector aligns with the hole in the
deck (Figure 18).
5. Secure the chute deflector in place with the flange lock nut
and hex screw removed in Step 2. Tighten to 102-124 in-lbs
(12-14 N-m) (Figure 18).
6. Skip ahead to Setting the Deck Wheels.
FOR 42/50/54 INCH DECK MODELS:
1. Check the tractor deck for a shipping brace that may be
holding the chute deflector upward for shipment. If the
brace is present, it must be removed before operating the
tractor. Holding the chute deflector fully upward, remove the
shipping brace. Lower the chute deflector and discard the
shipping brace (Figure 19).
Figure 19
Loading ...
Loading ...
Loading ...