Loading ...
Loading ...
Loading ...
(344,1)
北米Model "A1520BE-A" EDITED: 2022/ 11/ 22
X-MODE will automatically reacti-
vate when the vehicle speed drops
below 22 mph (35 km/h).
– When you use the cruise control
after X-MODE is automatically
deactivated, X-MODE will not be
automatically reactivated when
the vehicle speed drops below
22 mph (35 km/h).
. While the engine is running, if any of
the following conditions is met,
X-MODE will be deactivated. In this
case, it is not possible to activate
X-MODE. Also, the SI-DRIVE mode
will change to the Intelligent (I) mode
and it will not be possible to change
to the other modes.
– The CHECK ENGINE warning
light/Malfunction indicator light
illuminates.
– The AT OIL TEMP warning light
flashes.
– The ABS warning light illumi-
nates.
– The Vehicle Dynamics Control
warning light illuminates.
. The Auto Start Stop system will be
stopped while X-MODE is activated.
. If there is a possibility that the
engine could overheat because of a
temperature increase of the engine
coolant, it is not possible to activate
X-MODE. Even while X-MODE is
activated, X-MODE will be deacti-
vated when the engine coolant tem-
perature increases. In this case, the
SI-DRIVE mode will change to the
Intelligent (I) mode.
. The SI-DRIVE mode will not be
affected even if the SI-DRIVE switch
is pressed while X-MODE is acti-
vated. At this time, the buzzer will
sound twice.
Models with 2 modes:
. SNOW/DIRT is suitable for driving
on a snow-covered road where the
points of contact between the tires
and road surface are visible, or for
driving on an unpaved road.
. DEEP SNOW/MUD is suitable for
driving on a road covered with deep
snow where the points of contact
between the tires and road surface
are not visible, or for driving on a
muddy road.
& Hill Descent Control Function
s07bi03
The hill descent control function will be in
standby mode when X-MODE is activated
and the vehicle speed is less than approxi-
mately 12 mph (20 km/h).
The function will operate when the vehicle
speed is less than approximately 12 mph
(20 km/h) and the accelerator ratio is less
than approximately 10%.
The function will turn off when the vehicle
speed is more than approximately 12 mph
(20 km/h) and the accelerator pedal is
depressed.
CAUTION
The braking power of the hill des-
cent control function may not be
sufficient when strong braking
power is needed (e.g., when towing
a trailer).
NOTE
. Even while the hill descent control
function is operating, you can vary
the vehicle speed using the brake
pedal or accelerator pedal.
. During braking by the hill descent
control function, the stop lights will
illuminate.
X-MODE
342
Loading ...
Loading ...
Loading ...