Loading ...
Loading ...
Loading ...
(255,1)
北米Model "A1520BE-A" EDITED: 2022/ 11/ 22
! Gate Operator/Canadian Pro-
gramming
s03ap070410
Canadian radio-frequency laws require
transmitter remote signals to “time-out”
(or quit) after several seconds of transmis-
sion, which may not be long enough for
HomeLink
®
to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are de-
signed to “time-out” in the same manner.
The indicator LED on the hand-held
remote will go off when the device times
out, indicating that it has finished transmit-
ting.
If you live in Canada or you are having
difficulties programming a gate operator or
garage door opener by using the program-
ming procedures, replace “Programming a
New HomeLink
®
button” step 3 with the
following:
While the HomeLink
®
indicator light is
flashing orange, press and release (“cy-
cle”) your device’s hand-held remote every
two seconds until the HomeLink
®
indicator
light changes from orange to green. You
may now release the hand-held remote
button.
NOTE
If programming a garage door opener
or gate operator, it is advised to unplug
the device during the “cycling” process
to prevent possible overheating.
Proceed with “Programming a New
HomeLink
®
button” step 4 to complete.
! Using HomeLink
®
s03ap070411
To operate, simply press and release the
programmed HomeLink
®
button. Activa-
tion will now occur for the trained device
(i.e. garage door opener, gate operator,
security system, entry door lock, home/
office lighting, etc.). For convenience, the
hand-held remote of the device may also
be used at any time.
! Erasing HomeLink
®
buttons
s03ap070412
To erase programming from the three
buttons (individual buttons cannot be
erased but can be “reprogrammed” as
outlined below), follow the step noted:
Press and hold the two outer HomeLink
®
buttons for at least 10 seconds. The LED
indicator will change from continuously lit
to rapidly flashing. Release both buttons.
Do not hold for longer than 20 seconds.
HomeLink
®
is now ready to be pro-
grammed at any time beginning with
“Programming a New HomeLink
®
button”
- step 1.
! Reprogramming a Single
HomeLink
®
button
s03ap070406
To program a previously trained button,
follow these steps:
1. Press and hold the desired HomeLink
®
button. DO NOT release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The
HomeLink
®
button can be released at
this point. Proceed with “Programming
a New HomeLink
®
button” - step 3.
3. If you do not complete the program-
ming of a new device to the button, it
will revert to the previously stored
programming.
! Garage Door Two-Way Commu-
nication
s03ap070413
HomeLink
®
has the capability of commu-
nicating with your garage door opener.
HomeLink
®
can receive and display “clos-
ing” or “opening” status messages from
compatible garage door opener systems.
At any time, HomeLink
®
can also recall and
display the last recorded status commu-
nicated by the garage door opener to
indicate your garage door being “closed”
or “opened”.
HomeLink
®
has the capability of receiving
this communication from the garage door
opener at a range up to 820 feet (250 m).
– CONTINUED –
Mirrors
253
3
Instruments and Controls
Loading ...
Loading ...
Loading ...