Loading ...
Loading ...
Loading ...
SDG7000A User Manual
WWW.SIGLENT.COM 3 / 133
Identification of Normal State of Equipment.
After the device is started, there will be no alarm information and error information at the interface
under normal conditions. The curve of the interface will scan from left to right freely; if there is a
button, alarm or error prompt, the device may be in an abnormal state. You need to view the
specific prompt information. You can try to restart the setting. If the fault information is still in
place, do not use it for testing. Contact the manufacturer or the maintenance department
designated by the manufacturer to carry out maintenance to avoid the wrong test data caused
by the use of the fault or endanger the personal safety.
Do Not Operate With Suspected Failures.
If you suspect that there is damage to the instrument, please let only qualified service personnel
check it.
Avoid Exposed Circuits, Wire, or Components.
Do not touch exposed contacts or components when the power is on.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep the surface of the instrument clean and dry.
Only lithium batteries with the same specification could be used to replace the battery on
the main-board.
The responsible body or operator should refer to the instruction manual to preserve the
protection afforded by the device. If the device is used in a manner not specified by the
manufacturer, the protection provided by the device may be impaired.
Any parts of the device and its accessories are not allowed to be changed or replaced,
other than authorized by the manufacturer or agent.
Loading ...
Loading ...
Loading ...