Loading ...
Loading ...
Loading ...
3Connect your iPod or iPhone to PDX-50TX
(transmitter).
The green LED lights up if a wireless connection
between PDX-50TX and another Yamaha product is
established.
5To charge the iPod or iPhone, place it on
PDX-50BC.
/Status LEDs
PDXJ5;TX
LED Status
off An iPod or iPhone is not connected, or has
stopped playing. However, lights up for 30
seconds or 2 minutes (depends on the iPod/
iPhone) after connecting or stopping
playback.
Flashes green Connection m progress, please wait.
continuously
Adjusting the volun_e level.Flashes green
once
Lights up
green
A connection is established. You are ready
to start playback of iPod on another Yamaha
product.
l+ights up Flashes red lkw2 seconds: An unsupported
green and iPhone or iPod is colmected.
flashes red Keeps flashing red: Connection failed.
Flashes red The banery of the iPod or iPhone is tow.
(regardless of
green status)
4Adjust the angle of your iPod or iPhone so that it
is aligned parallel to PDX-50TX.
I
]
•Group selection switch
Use this switch to set the group ID. "lb establish a wireless
connection (yAired) with another Yamaha product, set
both the products to the same group.
Group selection switch
•PDX-50TX supports "1" (AlL "2" (A2), and "3" (A3)
on some Yamaha products that support "yAired'.
•Disconnecting the iPod or iPhone
To disconnect the iPod or iPhone from PDX-50TX
(transmitter), pull the iPod or iPhone upward.
t
?_1-_
Disconnection may be difficult under low temperature.
In this case, do not disconnect the iPod or iPhone by
force; loosen off the tab on the back of PDX-50TX to
make the disconnection easier.
SEn
Loading ...
Loading ...
Loading ...