Loading ...
Loading ...
Loading ...
Problem
Surround sound effects are
insubstantial.
Digital audio signals cannot be
played back. (Fit'1DIGITAL indicator
does not light up in the front panel
display.)
There is noise interference when a
subwoofer is not connected to this
unit.
Cause
The listening room is not a regular shape.
There is no wall in the path of the solmd beam.
The playback component is connected to this unit
with an analog connection.
The external component is nut set to output digital
audio signals.
Bit streaming is disabled on the external component.
The protection circuitry was in operation because a
source with strong bass elements was played back.
Remedy
Install this unit in asquare or rectangular shaped
rooIIl.
Try placing a fiat object, such as a board, in the path
of the sound beam.
Connect them with an HDMI connection or a digital
counectiou.
Refer to the owner's manual supplied with your
component and check the setting.
Refer to the owner's ruanual supplied with your
component and check the setting.
Turn down the volume level.
Set "BASS OUT" to "SUBWOOFER" in
"SUBWOOFER SET".
Connect a subwoofer and adjust settings Rw
"SUBWOOFER SET".
Connect the cable properly.On-screen display does not
appear.
Set "HDMI CONTROL" to "ON" in "SET MENU".The HDMI control function does
not work properly.
The automatic lipsync is not
effective even "AUTO LIP SYNC" is
set to "ON".
The cable is not connected to the TV or this unit
properly.
"HDMI CONTROL" is set to "OFF" in "SET
MENU".
The HDMI control function is disabled on your TV. Refer to the owner's manual supplied with your TV
and check the setting.
Disconnect some of the HDMI components.The number of the connected HDMI components is
over the limit.
The TV does not support the automatic lipsync.
The key is unable to functiun in the cmTent condition."Not Available" appears on the
front panel display after key
operation.
Set "AUTO LIP SYNC" to "OFF' and then manually
adjust the audio output delay.
•FM tuner
Problem Cause
FM stereo reception is noisy. The characteristics of FM stereo broadcasts may
cause this problem when the transmitter is too far
away or the antenna input is poor.
There is distortion, and clear There is multiq_ath interference.
reception cannot be obtained even
with a good FM antenna.
Tile signal is too weak.
The desired station cannot be
tuned into with the automatic
tuning method.
Remedy
Cheek tile antenna connections.
Try using a high-quality directional FM antenna.
Use the manual tuning method.
Adjust the antenna position to eliminate multi-path
interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Preset the stations again.
See
page
12
Remedy
Cheek the connection of the antenna aM
SiriusConnect tuner.
The message disappears normally within several tens
of seconds.
Check the connection of the SiriusConnect tuner and
this unit.
Connect the power cable of the SiriusConnect tuner to
the AC wall outlet.
21
36
36
12
39
36
See
page
14
25
25
25Previously preset stations can no This unit has been disconnected for a long period.
longer be tuned into.
•SIRIUS Satellite Radio
Status message Cause See
page
ANTENNA ERR Tile antenna is not connected to the SiriusConneet 26
tuner properly.
SIRIUS LOADING This unit is communicating with the SiriusConnect
tuner.
CHECK TUNER The SiriusConnect tuner is not connected to the
SIRIUS jaek of this unit correctly.
The SiriusConnect tuner is not connected to the AC
wall outlet.
26
26
44 En
Loading ...
Loading ...
Loading ...