Loading ...
Loading ...
Loading ...
INCLUDED ACCESSORIES
12
Using the Multi-Purpose Screwdriver
(Included with Some Models)
Since the screwdriver can be changed to three different
positions, it can be extremely useful for the various machine
preparations. With this machine, position “1” and position
“3” are used.
Using the Spool Stand (Included with Some
Models)
The included spool stand is useful when using thread spools
with a large diameter (cross-wound thread). The spool stand
can hold two spools of thread.
How to Assemble the Spool Stand
a
Fully extend the telescopic thread guide shaft, and then
rotate the shaft until the two internal stoppers click
into place.
b
Insert the telescopic thread guide into the round hole
at the center of the spool support, and then use a
screwdriver to securely tighten the screw from the
reverse side.
1 Screw
Position “1” You can install/remove the presser foot holder,
needle clamp screw or needle plate.
Position “3” The multi-purpose screwdriver can be
positioned over the screw on the embroidery
frame to tighten the screw after hooping the
fabric or when removing the fabric.
123
456
789
No. Part Name
1 Telescopic thread guide
2 Spool support
3 Spool pin × 2
4 Screw and washer
5Spool cap (XL) × 2
6Spool holder × 2
7 Spool cap base × 2
8Spool felt × 2
9Ring × 4
IMPORTANT
• Do not lift the handle of the machine while the
spool stand is installed.
• Do not push or pull the telescopic thread
guide or spool pins with extreme force,
otherwise damage may result.
• Do not place any object other than spools of
thread on the spool support.
• Do not try to wind thread on the bobbin while
sewing using the spool stand.
Note
• Make sure that the stoppers on the telescopic
thread guide shaft are firmly in place and that the
thread guide openings are directly above the two
holes for spool pins in the spool support. In
addition, check that the shaft is securely tightened
in the spool support.
Loading ...
Loading ...
Loading ...