Loading ...
Loading ...
Loading ...
NAMES OF MACHINE PARTS
10
Measurements on the needle plate and the bobbin cover
(with mark)
The measurements on the bobbin cover and needle plate are
references for stitch patterns with a left or middle (center)
needle position.
1 For stitches with a middle (center) needle position
2 For stitches with a left needle position
3 Left needle position on the needle plate <inch>
4 Left needle position on the needle plate <cm>
5 Middle (center) needle position on the bobbin cover
(with mark) <inch>
6 Middle (center) needle position on the needle plate
Embroidery unit
1 Carriage
The carriage moves the embroidery frame automatically when
embroidering.
2 Release lever (located under the embroidery unit)
Press the release lever to remove the embroidery unit.
3 Embroidery frame holder
Insert the embroidery frame into the embroidery frame holder
to hold the frame in place.
4 Frame-securing lever
Press the frame-securing lever down to secure the embroidery
frame.
5 Embroidery unit connection
Insert the embroidery unit connection into the connection port
when attaching the embroidery unit.
Operation Buttons
1 “Start/Stop” button
Press the “Start/Stop” button to start or stop sewing. The
button changes color according to the machine’s operation
mode.
2 Reverse stitch button
Press the reverse button to sew reverse or reinforcement
stitches depending on the selected stitch pattern. (page 55)
3 Reinforcement stitch button
Press the reinforcement button to sew a single stitch
repeatedly and tie-off. (page 55)
For character/decorative stitches, press this button to end with
a full stitch instead of at a mid-point.
The LED beside the button automatically lights up while the
stitch is being sewn and goes off when sewing is finished.
4 Needle position button
Press the needle position button to raise or lower the needle
position. Pressing the button twice sews a single stitch.
5 Thread cutter button
Press the thread cutter button after sewing to automatically
trim the excess thread.
6 Presser foot lifter button
Press the presser foot lifter button to lower the presser foot and
apply pressure to the fabric. Press this button again to raise the
presser foot.
7 Sewing Speed controller
Use the sewing speed controller to adjust the sewing speed.
Move the slide to the left to sew at slower speeds. Move the
slide to the right to sew at higher speeds.
8 Automatic threading button
Use the automatic threading button to automatically thread the
needle.
a
e
dc
b
Green: The machine is ready or is operating.
Red: The machine is not ready.
Loading ...
Loading ...
Loading ...