Loading ...
Loading ...
Loading ...
88
Figure 10-2 Sample VCI Bluetooth Pairing Screen
To pair the VCI device with the tablet via Bluetooth
1. Power on the tablet.
2. Connect the 26-pin end of the data cable to the VCI's vehicle data connector.
3. Connect the 16-pin end of the data cable to the vehicle Data Link Connector
(DLC).
4. Tap VCI Manager on the MaxiSys Job Menu of the tablet.
5. Select VCI BT (short for VCI Bluetooth), from the connection mode list.
6. Toggle Bluetooth ON. Tap Scan at the top-right corner. The device will start
searching for available units for pairing.
7. Depending on the VCI you use, the device name may appear as “Maxi” suffixed
with the serial number. Select the appropriate device for pairing.
8. When paired successfully, the connection status reads as “Connected”.
9. After a few seconds, the VCI button on the system Navigation Bar at the bottom
of the screen will display a green check mark, indicating that the tablet is
connected to the VCI device.
10. To disconnect the device, tap the connected device again.
11. Tap Back on the top-left to return to the MaxiSys Job Menu.
NOTE
A VCI device can be paired with only one tablet at a time, and once it's been paired, the
device will not be discovered by any other unit.
Loading ...
Loading ...
Loading ...