Loading ...
Loading ...
Loading ...
©2021 Sharp NEC Display Solutions, Ltd. Page 75 of 86
10. When in position, push the U.FL connector down onto the receptacle until it snaps into
place and is correctly seated. The top of the connector should be parallel to and at the
same height as the silver wireless module on the Compute Module. If the connector
does not snap into place, carefully inspect both sides for any damage and try again.
Figure 12.3-10 U.FL antenna connector seating on the Compute Module
11. Carefully inspect the antenna connectors and coax cable before proceeding to install the
heat-sink. Confirm that the coax cable is routed correctly and will not be pinched by the
heatsink and avoids being caught in the heatsink posts.
12. When the entire assembly is complete attach the external antenna to the bracket.
Figure 12.3-11 Attach external antenna
13. Proceed with installing the heatsink. See Section 2 on page 15
Loading ...
Loading ...
Loading ...