Loading ...
Loading ...
Loading ...
©2021 Sharp NEC Display Solutions, Ltd. Page 72 of 86
3. Visually inspect the antenna coax cable and connectors for damage such as kinks or bent
connectors. Do not attempt to install the cable and connectors if there is any damage.
4. Put the knurled washer on the SMA type external antenna connector.
Figure 12.3-3 Place knurled washer on external antenna connector
5. Push the antenna connector through the mounting hole on the bracket of the interface
board from the board side.
Figure 12.3-4 Insert antenna connector through Interface Board bracket
6. Put the compression washer and hex nut on the antenna connector from the external
side of the bracket. Hand-tighten the hex nut and tighten further using an 8mm hex
wrench or similar tool. Do not overtighten.
Figure 12.3-5 Place compression washer and hex nut
Loading ...
Loading ...
Loading ...