Loading ...
Loading ...
Loading ...
©2021 Sharp NEC Display Solutions, Ltd. Page 29 of 86
Figure 4.1-1: BOOT MODE switch - programming mode
d. Turn on the display’s AC power switch. Verify that the Compute Module is powered on.
Navigate the OSD to SLOT
COMPUTE MODULE POWER CONTROL POWER SUPPLY
and make sure ON is selected (displayed in yellow).
e. Verify that the Compute Module is powered on by looking at the LED indicator next to the
BOOT MODE switch. The LED should be red when power has been applied to the Interface
Board.
See the Troubleshooting section for “RPi Boot” is unable to detect the Compute Module
on
page 59 if the LED indicator does not illuminate.
6. Run the RPiboot application installed by the Compute Module boot installer by selecting “rpiboot”
from the Windows Start menu. A command window like the one shown below should appear and
close within a few seconds.
Loading ...
Loading ...
Loading ...