Loading ...
Loading ...
Loading ...
SDG7000A User Manual
48 / 133 WWW.SIGLENT.COM
After the arbitrary waveform is edited in the EasyWaveX, the waveform update can be completed
through the "Send Waveform to AWG" command under the "Communication" menu of the
software. Click File -> exit in the software menu bar to exit. It is recommended to use a mouse
to operate the software or operate it over WebServer.
For the use of EasyWaveX, please refer to the help of the software itself.
Application example: Set CH1 to output the AWG waveform of the following
parameters, and the data source is from the file edited by EasyWaveX
External load 50Ω
Sample rate = 160 MSa/s
Amplitude = 2.5V; Offset = 1.25V
The file has 160 points, and the waveform is a sine wave
Set the interpolation method respectively “Sinc” and”0-order hold”, and compare the
output waveforms.
1. On the carrier parameter setting page of CH1, set "Waveform" to "Arb" and "Mode" to
"AWG"
2. Set "Load" to 50 Ω
3. On the "Source" setting page, select "Source" as "EasyWaveX", and the device will
automatically call the built-in EasyWaveX application.
4. In the operation interface of the EasyWaveX, create a new blank waveform file through
File>Blank Waveform.
5. In the pop-up dialog box, set the number of points to “Variable" and 160 points in the
"Sample" column, and click OK.
Loading ...
Loading ...
Loading ...