Loading ...
Loading ...
Loading ...
SDG7000A User Manual
1 1 4 / 133
W W W . S I G L E N T . C O M
The specific operation steps are as follows:
1. After entering the multi-device synchronization setting interface, set the "Sync Status" of all
devices to "On".
2. Set one of the devices as "Master" and the other devices as "Slave".
3. Connect the [TRIG/SYNC] of the master to the [TRIG/SYNC] of other slaves respectively.
4. Connect the [10MHz Out] connector of the Master to the [10MHz In] connector of the first
Slave, and then connect the [10MHz Out] connector of the first Slave to the [10MHz In]
connector of the second slave, etc.
5. Set the same output frequency for all the generators.
6. Press the "Sync Device" button on the Master to apply synchronization.
Figure 16-1 wiring diagram of multi-device synchronization
The synchronous signal is transmitted from [TRIG/SYNC] of the Master to [TRIG/SYNC] of the
Slave(s) through the BNC cable when Sync Devices is pressed. There is a certain delay between
the moment when the master sends the synchronous signal and the moment when the Slave(s)
receive it. Therefore, the output waveforms from different generators will have a certain phase
difference related to the BNC cable. Users can adjust the phase of every Slave independently to
compensate for the phase difference.
16.4 Test/Cal
16.4.1 Perform Self-Test
The Self-tests include a screen test, keyboard test, and LED test. It is used to check whether the
device has any electrical or mechanical problems on the user interface such as color distortion,
the sensitivity of buttons and knobs.
Execute Utility > Test/Cal > Self Test to enter self-test setting page.
Loading ...
Loading ...
Loading ...