Loading ...
Loading ...
Loading ...
trouble shooting
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE TROUBLE
SHOOTING YOUR SANDER.
TROUBLE
Motor will not run.
i,i i
Machine slowsdown
when finishing,
ii ,....
Abrasive Belt Slips
Abrasive Belt runs
off pulleys.
Wood burnswhile
finishing.
TROUBLE SHOOTING CHART
PROBABLE CAUSE
1. Defective On-Off switch.
Defective switch cord.
Defective switch box receptacle.
2, Motor protector open, (only if
your motor is equipped with an
overload protector).
3. Burned out motor.
. u,,,,,,,,,,,_ ,
1. V-Belt too loose.
2. Applying too much pressureto
workpiece.
3. Too much tension on abrasive
belt,
,,,,,,,,,,,,J ,Ji,J
1. Not enough tension.
1. Not tracking properly.
2. Not enough tension.
"j.
2.
3,
1, Abrasivedisc or belt isglazed with
sap.
REMEDY
Repface defective parts before using belt disc
sander again.
Reset protector after motor has cooled,
Consult Sears Service. Any attempt to repair this
motor may create a HAZARD unless repair is
done by a qualified service technician. Repair
service is available at your nearest Sears Store.
,,, ,,,. i,l,,i , ,,,, ,,,,,i ,L,i i
!. Increase belt tension, seeAssembly Section,
"Motor Pulley Belt Guard and Motor
Installation."
2. Ease up on pressure.
3, Adjust tension, seeAssembly Section, "Installing
and Adjusting Abrasive Belt."
,,1,,,..................
1. Adjust tension, seeAssembly Section, "Installing
and Adjusting Abrasive Belt."
1. Adjust tracking, see Assembly Section, "Installing
and Adjusting Abrasive Belt."
2. Adjust tension, seeAssembly Section, "installing
and Adjusting Abrasive Belt."
1. Repi_e disc or belt,
...... ; -m-=_==_RECOMMENDED ACCESSORIES ...... ' --
ITEM CAT. HO.
Steel Stand .............................. 9-22213
Caster Set ....................... 9-22222, 9-22221
Miter Gauge ............................. 9-29929
Pressure-Sensitive cement .................... 9-2220
Abrasive Belts and Disc .............. SEE CATALOG
Steef Legs ............................... 9-22236
Power Tool Know How Handbooks
Radial Saw .............................. 9-2917
Table Saw .............................. 9-2918
The above recommended accessories are current and were avai{ableat the time this manual was printed.
23
Loading ...
Loading ...
Loading ...