Loading ...
Loading ...
Loading ...
gettincj 1toknow your belt and disc sander
f. Loosen the table positioning lock screw,,, posi-
tion the tab]e approximately 1/16"' away from
the abrasive disc.
g. Tilt the table dov_nward but don't tighten the lock
screw, and position it as close to the disc as pos-
sible. Using the head of a combination square,
check the angle of the table with the disc.
h. If the table is not 45 ° with the disc:
i. Raise the table and loosen the lock nut using a
7116" wrench.
j. Screw the stop screw in or out, using a 3/8"
wrench so that when the table touches it, it is 45 °
with the disc.
k, Tighten the lock nut.
LOCK NUT
STOP SCREW
-- .J_,,____ l!ll ,____11 , _LI! , llJ 1'11' , I , I ' iii ., "n_'l I' 11111 _£U
4. BACKSTOP LOCK SCREW locks the backstop in
place, it is locked using the 1/2" wrench,
BACKSTOP
LOCK SCREW
\
\
BACKSTOP
, ,, i, i ,iiii,i,,i,,. , iIi
iiiii,i,i
5. BELT TABLE LOCKING BOLTS
belt table in position.
To adjust to vertical position:
... lock the
a. Remove the backstop,
b. Loosen the two belt table locking boffs using the
1/2" wrench supplied with your machine.
c. Position belt table vertically and tighten the two
bolts.
6. ABRASIVE BELT TABLE STOP can be adj-
usted so that the abrasive belt table is level with
the floor when in a horizontal position,
a. Loosen the lock nut using a 314" wrench.
b. Place a level on the abrasive belt table and using a
3/4"" wrench, screw the stop bolt in or out until
the table is level.
BE LT TABLE
LOCKING BOLT
lg
LOCK NUT
STOP BOLT
Loading ...
Loading ...
Loading ...