Loading ...
Loading ...
Loading ...
basic operation
FINISHING CURVED EDGES ON THE
ABRASIVE BELT
CURVED EDGES
Finish outside curves on the abrasive belt and inside
curves on the idler pulley.
FINiSHiNG SMALL END SURFACES AND
CURVED EDGES ON THE ABRASIVE DISC
Move the work across the "Down Side" of the face of
the abrasive disc. For accuracy, usea miter gauge.
NOTE: Use a combination square to square the miter
gauge to the face of the disc. If it is not square, pull out
the index pin, loosen the miter gauge knob and move the
miter gauge s]ightly until it is square. Without moving
the miter gauge,tighten the knob securely.
SQUARE
MITER GAUGE
Applying the workpiece to the "Up Side" could cause it
to fly up (kickback) which could be hazardous.
The table may be tilted for beveled work.
2t
Loading ...
Loading ...
Loading ...