Loading ...
Loading ...
Loading ...
SURFACE COOKING
Low: Use to simmer foods, keep foods
warm and melt chocolate or butter. Some
cooking may take place on the Low
setting if the pan is covered. It is possible
to reduce the heat by rotating the knob
toward OFF. Be sure flame is stable.
High: Use to bring liquid to a boil, or reach
pressure in a pressure cooker. Always
reduce setting to a lower heat when liquids
begin to boil or foods begin to cook.
An intermediate flame size is used to
continue cooking. Food will not cook any
faster when a higher flame setting is used
than needed to maintain a gentle boil.
Water boils at the same temperature
whether boiling gently or vigorously.
Surface Controls
BURNER CAP
Pilotless
ignition
Pilotless ignition eNminates the need for
a constant standing pilot Nght. Each
surfaceburnerhasaspark
ignitor. Use care when
cleaning around the surface Po,_,
Ignitor
burner.
If the surface burner does not Iig
check if ignitor is broken, soiled or wet. BUBNEBBASE
Surface Control Knobs
Use to turn on the surface burners. An infinite choice of heat
settings is available from Low to High. The knobs can be set
on or between any of the settings.
Graphics next to the knob identify which burner
-_110 the knob controls. For example, the graphic at left
Front shows the right front burner location.
Setting the controls:
Tile size and type of cookware will affect the heat setting.
1. Place a pan on the burner grate.
* The burner flame may lift off or appear separated from
the port if a pan is not placed on the grate.
2. Push in and turn the knob counterclockwise to the Light
setting.
* A clicking (spark:)sound will be heard and the burner
will light. (All of the ignitors will spark whenever any
surface burner knob is turned to the Light position.]
3. After the burner lights, turn the knob to the desired
flame size.
, The ignitor will continue to spark until the knob is
turned past the Light position.
Operating During a
Power Failure
1. Hold a lighted match to the desired surface burner head.
2. Push in and turn the control knob slowly to Light.
3. Adjust the flame to the desired level.
12
Loading ...
Loading ...
Loading ...