Loading ...
Loading ...
Loading ...
ENABLING AND DISABLING THE
PARKSENSE ACTIVE PARK ASSIST
SYSTEM
The ParkSense Active Park Assist system
can be enabled and disabled with the
ParkSense Active Park Assist switch, located
in front of the center console, to the rear of
the gear selector.
To enable the ParkSense Active Park Assist system,
push the ParkSense Active Park Assist switch once
(LED turns on). Pushing the switch a second time will
disable the system (LED turns off).
The ParkSense Active Park Assist system will turn off
automatically for any of the following conditions:
•
Parking maneuver is complete.
•
Vehicle speed is greater than 18 mph (30 km/h)
when searching for a parking space.
•
Vehicle speed is greater than 5 mph (7 km/h) dur-
ing active steering guidance into the parking space.
•
Steering Wheel is touched during active steering
guidance into the parking space.
•
ParkSense Front and Rear Park Assist switch is
pushed.
•
Driver's door is opened.
•
Rear liftgate is opened.
•
Electronic Stability Control/Anti-lock Braking System
intervention.
The ParkSense Active Park Assist system will allow a
maximum number of shifts between DRIVE and
REVERSE. If the maneuver cannot be completed within
the maximum amount of shifts, the system will cancel
and the instrument cluster display will instruct the
driver to complete the maneuver manually.
The ParkSense Active Park Assist system will only oper-
ate and search for a parking space when the following
conditions are present:
•
Gear selector is in DRIVE.
•
Ignition is in the RUN position.
•
ParkSense Active Park Assist switch is activated.
•
Driver's door is closed.
•
Rear liftgate is closed.
•
Vehicle speed is less than 18 mph (30 km/h).
•
The outer surface and the underside of the front
and rear fascias/bumpers are clean and clear of
snow, ice, mud, dirt or other obstructions.
NOTE:
If the vehicle is driven above approximately 15 mph
(25 km/h), the instrument cluster display will instruct
the driver to slow down. If the vehicle is driven above
approximately 18 mph (30 km/h), the system will can-
cel. The driver must then reactivate the system by push-
ing the ParkSense Active Park Assist switch.
When pushed, the LED on the ParkSense Active Park
Assist switch will blink momentarily, and then the LED
will turn off if any of the preceding conditions are not
present.
If the vehicle is in any other gear than DRIVE, and an
objected is detected, the system will default to Parallel
Park Exit. A prompt will appear in the radio screen, and
the driver will need to select “Yes” or “No” for a Parallel
Park Exit maneuver. Any other conditions will result in a
default to a Parallel Parking maneuver.
PARALLEL/PERPENDICULAR
PARKING SPACE ASSISTANCE
OPERATION
When the ParkSense Active Park Assist system is
enabled, you can select between Parallel, Perpendicu-
lar, and Parallel Park Exit maneuvers in the Uconnect
system.
NOTE:
•
When searching for a parking space, use the turn
signal to select which side of the vehicle you want to
perform the parking maneuver. The ParkSense
Active Park Assist system will automatically search
for a parking space on the passenger's side of the
vehicle if the turn signal is not activated.
•
The driver needs to make sure that the selected
parking space for the maneuver remains free and
clear of any obstructions (e.g. pedestrians, bicycles,
etc.).
Choose Parking Maneuver Below
126 STARTING AND OPERATING
Loading ...
Loading ...
Loading ...