Loading ...
Loading ...
Loading ...
GENERAL INFORMATION
Whirlpool Smart All-In-One Washer & Dryer
n
1-11
Clean Washer Cycle Reminder
The Clean Washer with aresh® message will ash at the end
of a wash cycle when the washer has run 30 wash cycles. This
is a reminder to run the Clean Washer with aresh® cycle.
If the Clean Washer with aresh® cycle is not run, the message
will stop ashing at the end of a wash cycle aer running
three more regular wash cycles. Aer 30 more wash cycles are
completed, the Clean Washer with aresh® message will again
ash at the end of a wash cycle as a reminder.
Removing the Load & Go Bulk
Dispenser
To remove:
1. Li the bulk dispenser lid on the top of the washer/dryer.
2. Li up on the bulk dispenser handle and pull straight up
and out of the washer/dryer.
To replace:
1. Place the bulk dispenser back into the bulk dispenser
cavity on the top of the washer/dryer and make sure that
it is seated.
2. Close the bulk dispenser lid.
All-In-One Washer/Dryer Maintenance (continued)
Water Inlet Hose
Replace inlet hose aer 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hose if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hose:
n Mark the date of replacement on the label with a
permanent marker.
n Check that the old washer is not stuck on the washer inlet valve.
n Use a new washer in the new inlet hose to ensure a proper seal.
If moving, or not using your washer/dryer for a period of me,
follow these steps:
1. Unplug or disconnect power to washer/dryer.
2. Turn o water supply to washer/dryer to avoid ooding
due to water pressure surges.
HELPFUL TIP: Aach a reminder note to the washer/dryer
to turn the water back on before washer’s next use.
3. Clean the bulk dispenser. See “Cleaning the Bulk
Dispenser.”
Winter Storage Care
IMPORTANT: To avoid damage, install and store washer/dryer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer/dryer. If storing or moving
during freezing weather, winterize your washer/dryer.
To winterize washer/dryer:
1. Shut o water faucet, disconnect and drain water inlet
hose.
HELPFUL TIP: Aach a reminder note to the washer dryer
to turn the water back on before washer’s next use.
2. Remove drain pump lter.
3. Put 1 qt. (1 L) of R.V.-type anfreeze in drum and run
washer on Normal cycle for about 2 minutes to mix
anfreeze and remaining water.
4. Unplug washer/dryer or disconnect power.
Loading ...
Loading ...
Loading ...