Loading ...
Loading ...
3
SPORTDOG.COM
TEKV1.5LT:
Please read and follow the instructions in this manual. Proper fit of the collar is important. A collar worn for too
long or made too tight on the dog’s neck may cause skin damage. This is called bed sores; it is also called decubitus
ulcers or pressure necrosis.
• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible, reposition the collar on the dog’s neck every 1 to 2 hours.
• Check the fit to prevent excessive pressure; follow the instructions in this manual.
• Never connect a lead to the electronic collar; it will cause excessive pressure on the contacts.
• When using a separate collar for a lead, don’t put pressure on the electronic collar.
• Wash the dog’s neck area and the contacts of the collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.
For additional information on bed sores and pressure necrosis, please visit the Support section for Remote Trainers
at www.sportdog.com.
These steps will help keep your dog safe and comfortable. Millions of dogs are comfortable while they wear Contact
Points. Some dogs are sensitive to contact pressure. You may find after some time that your dog is very tolerant of
the collar. If so, you may relax some of these precautions. It is important to continue daily checks of the contact area.
If redness or sores are found, discontinue use until the skin has fully healed.
• You may need to trim the hair in the area of the Contact Points or switch to the longer Contact Points to ensure
consistent contact. Never shave the dog’s neck; this may lead to a rash or infection.
• You should not make the collar any tighter than is required for good contact. A collar that is too tight will
increase the risk of pressure necrosis in the contact area.
TEKV1.5L:
Please read and follow the instructions in this manual. Proper fit of the collar is important.
• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible, reposition the collar on the dog’s neck every 1 to 2 hours.
• When using a separate collar for a lead, don’t put pressure on the electronic collar.
• Wash the dog’s neck area and collar weekly with a damp cloth.
• Avoid chemical cleaners and solvents that can damage plastic components.
• Do not store the TEK Series 1.5 System where prolonged exposure to temperature extremes may occur, because
permanent damage may result.
• When storing the device for an extended time, store within the temperature range of 0° to 25°C
(from 32°F to 77°F).
• Do not leave the device exposed to a heat source or in a high-temperature location, such as in the sun in an
unattended vehicle. To prevent damage, remove the device from the vehicle or store it out of direct sunlight,
such as in the glove box.
• In a typical training situation a user will not exceed 100 seconds of transmission time per hour, equating to 294
unique commands.
• Always confirm legal hunting times with the appropriate local hunting and shooting associations.
Loading ...
Loading ...
Loading ...