Loading ...
Loading ...
Loading ...
14
SPORTDOG.COM
GETTING STARTED
CONVERT A GPS COLLAR TO A GPS COLLAR WITH ECOLLAR MODULE
1. Remove the 2 outer screws from the Location-Only
Module with a 3/32 Allen wrench (A).
2. Separate the Location-Only Module from the GPS
Collar’s front housing (B).
3. Thoroughly clean inside the front housing with a
soft towel, removing any debris.
4. Before installing the E-Collar Module, check to
make sure the GPS Collar mount, antenna base and
antenna cable have not become dislodged (C).
• Ensure the GPS Collar mount is seated properly in
the front housing and that the GPS Collar mount
plug is securely in place.
• Ensure the antenna base is seated firmly on top of
the GPS Collar mount and that the antenna cable is
routed properly through front housing channel.
5. Install the E-Collar Module onto the GPS Collar’s
front housing. Ensure that the E-Collar Module is
fully seated before replacing the screws (D).
6. Replace the 2 outer screws being careful not to
over-tighten (E).
NOTE: If you own the TEK Series 1.5 GPS Tracking System (TEK-V1.5L), you must purchase the TEK Series E-Collar
Module accessory to utilise E-Collar functionality.
A
D
B
E
C
Antenna base
Antenna cable
GPS Collar mount
GPS Collar mount plug
Loading ...
Loading ...
Loading ...