Loading ...
Loading ...
Loading ...
Throttle Cable
Inspection
The throttle cable hQusing may need to be adjusted
periodically because the cable stretches, When fully
depressing the throttle pedal no longer activates full
engine speed, adjust the throttle cable housing.
Throttle Cable Housing Adjustment (See
Figure 21)
1. Fully loosen the jam nuts (1) and (2) and mount
the throttle cable housing to the frame. Make sure
the throttle pedal is against the rear pedal stop (3).
2. Pull the throttle cable housing toward the rear of
the Fun-Kart until you feel resistance.
_ WARNING: DO NOT pull the throttle cable
housing any further.
3. Hold the throttlecable housing inthis position
and screw the front jam nut (2) against the frame.
WARNING: Pulling the throttle cable housing
past the first point of resistance will engage the
engine throttte while the throttle pedal is in the
idle position. Upon starting the engine, the
vehicle may accelerate.
4. Screw the rear jam nut (1) against the frame.
5. Tighten the front jam nut (2) securely.
6. Make sure the engine throttle linkage is in the idle
position and the throttle pedal is against the rear
stop.
7. Block the rear end of the Fun-Kart off the ground
and start the engine. If the engine is not at idle
speed, stop the engine and repeat the above
procedures.
_i_ WARNING:The engine must be at idle speed
when the throttle pedal is in the rear position.
Failure to adjust the throttle properly may result
in personal injury and/or vehicle damage. If you
are unable to properly adjust the throttle, contact
your dealer for assistance.
•_ WARNING: Make sure exposed end of
throttle cable does not interfere with throttle
mechanism or cable end does not come in
contact with engine ground terminal.
MK021
Figure 21. Throttle Cable Housing Adjustment
42
Loading ...
Loading ...
Loading ...