Loading ...
Loading ...
Loading ...
BRAKETEST
_!1_WARNING: DO NOT operate this Fun-Kart
unless the brake is working properly.
• BEFORE Fun-Kart operation, ensure the
effectiveness of the brake system.
Perform this test BEFORE each operation.
1. Sit in the Fun-Kart. Make sure there is a clear
path ahead and depress the brake pedal,
2. Start the engine.
a) On Fun-Karts without an electric starter, have
an assistant start the engine,
b) On Fun-Karts with an electric starter, use the
ignition switch to start the engine.
3. Increase engine RPM to make sure brake is
effective and continue to increase RPM to make
sure Fun-Kart does not move.
a) If brake does not hold the Fun-Karl, adjust as
described in the section MAINTENANCE;
Brake Service.
b) If proper brake performance cannot be
achieved using the described adjustment
procedure, contact your dealer for assistance.
_1_ WARNING: Do not use the Fun-Kart until
brake has been adjusted correctly and is
functioning properly.
NOTE; Brake systems typically require a short break-
in period to operateat full efficiency. Minor wear on
the lining or pads will improve effectiveness. This can
be accomplished by making a series of gentle stops.
Hard usage of the brakes without proper break-in or
riding the brakes (brakes partially applied while
applying the throttle) can result in reduced life of the
lining or pads and decreased braking ability. DO NOT
apply pressure to brake pedal while riding except for
speed control or stopping.
PARKING Bi_AKE TEST
NOTE: This test applies ONLY if your Fun-Kart is
equipped with a parking brake.
_1_ WARNING: If the parking brake does not
provide adequate braking, it is not to be used
during engine start-up.
_t_ WARNING: DO NOT use the parking brake
unless the following test is satisfactorily
performed.
1. Set parking brake and clear a path ahead of the
Fun-Karl.
2_ Sit in Fun-Kart and have an assistant start
engine.
3. Slowly increase engine RPM to make sure
parking brake is effective and continue to
increase RPM to make sure Fun-Kart does not
move.
4. If the parking brake is not effective see your
dealer for repair or adjustment. DO NOT operate
the Fun-Kart with a malfunctioning parking brake.
Seat Adjustment (See Figure 4)
Some Fun-Karts are equipped with a multi*position,
adjustable seat. The seat must always be securely
fastened in the position which gives the operator
complete range of motion of the foot pedals, steering
wheel and engine stop switch. If this can not be
achieved, the operator is too small or too large for
proper Fun-Kart operation.
_1_ WARNING: Never operate this Fun-Kart
when the provided seat is not securely fastened
to the Fun-Kart frame. This may result in severe
personal injury or loss of life.
A
_BL CAUTION: Before attempting to adjust the
seat, make sure engine is stopped. DO NOT
adjust the seat while Fun-Kart is moving.
1. Adjusting seats with seat slides:
a) Make sure engine is stopped
b) Move the lever under the seat pad to the 1eft
and slide the seat into the proper position.
2. Adjusting fixed seats:
a) Make sure engine is stopped.
b) Remove the four nuts from the seat mounting
screws as shown. It may be necessary to
remove the seat cushions from the seat
frame.
c) Move seat to desired position and align seat
frame above the corresponding holes in the
mounting plates on Fun-Kart frame.
d. Reinstall four seat mounting screws down
through seat frame and frame plates and
attach nuts.
e. Securely tighten all fasteners. Replace
Iocknuts if necessary.
21
Loading ...
Loading ...
Loading ...